Breakover
Member
Update: Haven't had the issue since. No clue what happened that caused my system to mess up like that. The only thing I changed was flipping the tank and burping off some liquid tane from the vent valve. I didn't notice any water coming out, but something fixed itself.
Maybe the gas "re wetted" the packing gland? Be interested to see if it leaks again and if inverting it fixes the leak.
Hey guys, im staying calm over hear. Im not freaking out, I promise.. but I need to clarify this before I conclude that I effed up. I got pieces of tubing cut and had all my welds done on the inside of the lids.
Is it absolutely necessary to have any further steps to be taken? The welder told me he would wire brush off any burrs or spatter. What are the conditions that will cause any parts of this to rust? Will it happen right away, within a few uses, if cooled too much, if heated too much?
Ive spent a shit ton of money to make all this, now im feeling like I have to spend half a stack more on annealing (or more) or spend around the same to buy new parts and not modify any steel inside the CLS.
Run it and see. Never had a problem with internal rust on welded parts to date.