The two different numbers should represent 110/220 amp rating.I think I read st, tsomething like "AMPS 6.0 / 9.5 ? I took this to mean, the 9.5 is max and was guessing that was at the strike?
The two different numbers should represent 110/220 amp rating.I think I read st, tsomething like "AMPS 6.0 / 9.5 ? I took this to mean, the 9.5 is max and was guessing that was at the strike?
Can you get to the middle of that circle if you need to. Might be helpful to have a access port to do training and trimming. Or to replace a bulb or fan.
Have you flipped them yet. Smells like money.
The two different numbers should represent 110/220 amp rating.
Hazed - Here's those coco recipes I said i'd put up for ya.
Conni - 5ml A + 5ml B per gal. Fed every watering clone til final flush
Jacks - 2g per gal of each 5-12-26 and cal nit.
Fed every watering clone til final flush
Well "Breakfast time" kinda came and went! Discovered a pretty bad light leak from underneath and will head to Home De Pot tomorrow and see if there is something cheap I can cover the floor with.
If it is along the bottom of the walls just shovel a little sand around the outside.
Hazed - You might try the 20-20-20 @ 1 tablespoon per 5 gals. Every watering clone til flush. This might be a bit strong for coco so check your EC and water it down if necessary. This is an old timer recipe for promix, but the profile looks like it should work fine for coco also. Kind of sits right between h3ad's recipe and the lucas formula.
I`m proud to have such knowledgeable help and spot on info from a different perspective.......and yeah....Freds is right about the bulb, but it depends on your goals too. Looks to me like those plants could use some bushing out before the flip or even during stretch if you are dead set on them staying flipped. I would raise the bulb til the middle of the bulb is even with the top of the plants during the stretch. This will encourage more bushing and less vertical stretch, but again this is a personal choice based on the goals of the grower. Would like to see how the mantis are getting along
Freds is right about the bulb, but it depends on your goals too. Looks to me like those plants could use some bushing out before the flip or even during stretch if you are dead set on them staying flipped. I would raise the bulb til the middle of the bulb is even with the top of the plants during the stretch. This will encourage more bushing and less vertical stretch, but again this is a personal choice based on the goals of the grower. Would like to see how the mantis are getting along
I`m proud to have such knowledgeable help and spot on info from a different perspective.......and yeah....
Makes total sense with those smaller plants , and as a rule the plants usually bush out toward the bare bulbs regardless.....but in what time frame is a different story , as well as not gettin too close to each other and choke each plant out for light and environment.....
Ahhhh......The path to Nirvana......a long and bumpy road.......but....
Done more easily with dedication and medication......
Hazed.....We`re here for yas my buddy....Gonna make yas a rock star......Just watch yer 6 and stay safe.....
Peace.....Freds........
yeah those plants need some foliar spraying with Cal-Mag twice a week with a surfactant... if ya can't afford it, just use a tiny drop per Liter or 2. of basic dish soap.. helps the water stay on the surface of the leaves and get absorbed. Has a slight anti pest effect too!
i wanna see this take off too!!
i don't know the dosage rate. Although starting at about 500ppm is good. Then every week you can add 150ppm until about 1000ppm from experience... i used grotek's 2-0-0 Cal Mag and it's 5mL per Liter
i don't know the dosage rate. Although starting at about 500ppm is good. Then every week you can add 150ppm until about 1000ppm from experience... i used grotek's 2-0-0 Cal Mag and it's 5mL per Liter