I still have a clone of her, but I'm not sure when I'm gonna try flowering that strain again. It was in it's own room in isolation because it hermied, and a heat wave got it while I was on vacation.
All around I was fairly disappointed with my results this first run. I don't think I was running the genetics I was told I was running, or if I was, they'd been contaminated by something weaker like hemp. Still they were solid midgrades, so I can only complain so much. My next wave in flower contains HTC North #1, and Esbe's C99XDC. North #1 had some problems in early flower, but nothing genetic, they just got overheated badly one week and it hit some of them harder than others. C99XDC is not as far along as North #1, but it's gorgeous, filling out really nicely.
I haven't updated this thread in a while since I've been so busy building my new cabinet. It's almost finished. I'm hoping the HPS will improve finishing times, and add some critical red spectrum. Also the HPS will take care of the tops and the tubes will allow me to not worry about penetration. Just have to add the ductwork and then connect the power feed. I'm really hoping this combination of light styles works as well as I think it will!
All around I was fairly disappointed with my results this first run. I don't think I was running the genetics I was told I was running, or if I was, they'd been contaminated by something weaker like hemp. Still they were solid midgrades, so I can only complain so much. My next wave in flower contains HTC North #1, and Esbe's C99XDC. North #1 had some problems in early flower, but nothing genetic, they just got overheated badly one week and it hit some of them harder than others. C99XDC is not as far along as North #1, but it's gorgeous, filling out really nicely.
I haven't updated this thread in a while since I've been so busy building my new cabinet. It's almost finished. I'm hoping the HPS will improve finishing times, and add some critical red spectrum. Also the HPS will take care of the tops and the tubes will allow me to not worry about penetration. Just have to add the ductwork and then connect the power feed. I'm really hoping this combination of light styles works as well as I think it will!