Terpp
Member
We had a client request a MK III Terpenator with bidirectional flooding support.
When I went to the drawing board I wanted this bidirectional design to use as little hoses and valves as possible.
In the end we only needed to add the following:
(1) 1/4" WOG valve
(1) 24" 1/4" PTFE hose w/ 1/4" female swivel ends
(2) 1/4" 3-Way Tees
(2) 1/4" Flare x 1/4" NPT Stainless fitting.
(3) 1/4" Close
I also had to flip the valve upside down and turn the handle around to make room.
Client has been using it now for a few weeks with no problems.
I wanted to share this design with anyone that is thinking about building something like this for their MK III. Please let let me know if I can answer any questions.
When I went to the drawing board I wanted this bidirectional design to use as little hoses and valves as possible.
In the end we only needed to add the following:
(1) 1/4" WOG valve
(1) 24" 1/4" PTFE hose w/ 1/4" female swivel ends
(2) 1/4" 3-Way Tees
(2) 1/4" Flare x 1/4" NPT Stainless fitting.
(3) 1/4" Close
I also had to flip the valve upside down and turn the handle around to make room.
Client has been using it now for a few weeks with no problems.
I wanted to share this design with anyone that is thinking about building something like this for their MK III. Please let let me know if I can answer any questions.