G
Guest
i just finished framing the new space.
It has two 4 x 4 closets side by side with the clone, mothers, and veg on one side and flower on the other.
I wiill have a 17" x 32" e&f table with a 250W mh hanging above. I will have a aeroclone 20 on a shelf with a pair of 24" agrosun flouros fixed in place about 18" above. I have a pair of 100W mh that I will use over my mothers. the layout should leave room for 6-8 5 gallon buckets for semi-permenent mother plants. I have a new portable a/c that can still sit in the corne of the space.
The flower room is 4 x 4 and I will start with a 2 x 2 e&f table in the middle with a 600W HPS Hortilux above. I will eventually jump to a 3x3 table with a 1000w hPS above. I have room at the top(9' ceilings) to put a charcoal filter in the top exhausting into the attic. When I sheet rock the center deviding wall I will put vents from the top to the bottom of the stud cavity to pull air through both rooms drawin the heat off of the ceiling in each room. I have a 440cfm fan that I will put on the charcoal filter and get a 265cfm to hook directly to the 600W air cooled reflector.
Just about done but it's been raing and I can go get sheet rock.
This weekend maybe
Tex
It has two 4 x 4 closets side by side with the clone, mothers, and veg on one side and flower on the other.
I wiill have a 17" x 32" e&f table with a 250W mh hanging above. I will have a aeroclone 20 on a shelf with a pair of 24" agrosun flouros fixed in place about 18" above. I have a pair of 100W mh that I will use over my mothers. the layout should leave room for 6-8 5 gallon buckets for semi-permenent mother plants. I have a new portable a/c that can still sit in the corne of the space.
The flower room is 4 x 4 and I will start with a 2 x 2 e&f table in the middle with a 600W HPS Hortilux above. I will eventually jump to a 3x3 table with a 1000w hPS above. I have room at the top(9' ceilings) to put a charcoal filter in the top exhausting into the attic. When I sheet rock the center deviding wall I will put vents from the top to the bottom of the stud cavity to pull air through both rooms drawin the heat off of the ceiling in each room. I have a 440cfm fan that I will put on the charcoal filter and get a 265cfm to hook directly to the 600W air cooled reflector.
Just about done but it's been raing and I can go get sheet rock.
This weekend maybe
Tex
Last edited: