Diary padre sereno garden

[hazepadano]

started the fourth day I think it will be possible to clean up and go 12/12 in 120x120.

the lamp is 25 cm from the tops at 60% power, temperatures in the order of 28 degrees ur 60-70%

 

[hazepadano]

end of the first part, finished the vegetation, gave a nice month, let's start the middle age, the extension!

 

[hazepadano]

come out clean and pruned the plants, I put 12 3x4
plant just released, comparison between pre and post pruning plant (on the left the one already pruned)

 

[hazepadano]

beginning of the second part
disassembled the box 100x100 I am placed in half 120x240, so we are in 120x120.
for one or two weeks they will share the box with a ride under hps (now 400 watts on the right), later I will take another fc 4800 lamp and goodbye hps

 

[hazepadano]

end first

 

[hazepadano]

below 480 watts we are at the end of second. They should finish in 8-9 weeks. I wait a few more days then do a clean up
it's hot but, for now I have no trouble

 

[hazepadano]

second end!
stuffed inside 12 new ones in 6.5 liter pots at the left under the 300 fce.
I'm considering whether to put another 480 immediately or if I'm going to pull (caldazza) under the 300

 

[hazepadano]

to fourth seventh

 

[hazepadano]

end of the fifth week

 

[hazepadano]

complete box 120x240 fc4800 end fifth, fce3000 third

 

[hazepadano]

we are on the sixth

 

[hazepadano]

we have entered the seventh week.
they had a nice drain (I suppose due to the thrust of k), so much so that the sundresses begin to yellow.
we should be on schedule but, maybe I have trodden a little too much (ec 3300 are at 8 ml / l of pk and that's it).
the red petiole makes me strange ....
now I go down to 2800 for a week and then I work (I plan to close in a maximum of 3 weeks)
the real fear is botrytis .... I have an important mass of buds ... I have a fan underneath that pushes a lot, I have oversized air changes (a 200 always on and a centrifugal 150 that starts an hour earlier and yes turns off 2 hours after switching on the lights).
with lights off I have 28-30 degrees and ur of 40% with lights on 30-32 at ur 60%.
the part under fce 3000 is on the fifth, we are a ec 2600 (a + b + pk)
I am attaching photos, note the discharge in 2 weeks ... at the fifth they were emerald green, at the sixth they clawed, at the seventh they started unloading.

 

[hazepadano]

forward octave ....
milky trichomes with first amber, many transparent.
they are draining (I gave a nice irrigation to water, now I will continue).

 

[hazepadano]

generally this plant ends up in 9 weeks (even 8 if you don't push it to important dimensions) here it seems to me that it still has a couple of good ones and this is a problem, they have run out of petrol!
I lowered the watts to 75%.
I had already noticed with the 300 watt an "extension" of a week compared to the hps well justified, in the first test, by a more than good harvest.

 

[hazepadano]

here I am hesitant (and I play the knave ...)
they have arrived, there is no more petrol.
it would take 2 weeks, I give it one (which then becomes 2 in the cut ....)
I have spider in some places (not exaggerated, it is not "the" problem)
I found botrytis in a cimetto (this takes me away from sleep).
I cut a little wire and tested

 

[hazepadano]

I don't seem to be too far behind .... they have a stench of diesel that heartens me, I would say that we are at the end of the seventh, what do you think?
ninth week

 

[hazepadano]

after the ninth I started to cut some secondary branches in these days I am working

 

[hazepadano]

cut!

 

[hazepadano]

they weren't very ripe but I had a good percentage of brown trichomes.
as I feared (last photo) a couple of cimozze taken from botrytis, nothing devastating but, how boring, we will use gas!
I dried trying to take at least 5 days. it's hot and dry, the test (30g) dried up in 3 days ...
the frames are 100x40, the dryer is the usual "lying" box with a 100 extractor and rino filter

 

[hazepadano]

Pensavo di provare una concia nell essiccatoio. L'essiccatoio ha un estrattore, pensavo di tararlo al 65% di ur. La stanza ha un ur media del 50-60%. All interno dell essiccatoio appena metto l'erba hai 70-80% di ur, l'estrattore ti dà giri di aria e secca. Ho una sonda che al 60% mi avverte (li decido se andare avanti a seccare o imbarattolare e conciare).
Se l'estrattore a 65% di ur si spegne dovrebbe essere come se il barattolo è chiuso. Passa il tempo l'erba rilascia umidità e l'estrattore riparte ecc ecc.
Forse basta temporizzarlo... Il concetto è portarla subito al 65% e scendere al 60-55% in una decina di giorni