thehappyguy
Member
well i figured i would go ahead and start this since it's getting to be about time for me to start another grow and my cab has changed so much. my first grow (in my sig) served as a very good learning experience, showing me things like how tough these plants really are and how to water/take care of them. i'll be running bagseed again, but this will probably be my last run with bagseed since i'll probably be ordering seeds. the whole reason i'm starting a new grow is because I'M MOVING! always good to start right when you get there, even though i'm using pl-ls, better safe than sorry. i've been adjusting and changing the cab and though i'm still going to fix a few things, it is more or less finished. i'm running heat tests right now (too high ) and then i just want to get some real black/white poly instead of my makeshift curtain, add a carbon filter, and i'm ready to go.
lights in the room on, lights in the room off, the sheet i made from black plastic and white vinyl...it needs to be replaced. hopefully when replaced with real black/white poly, i can get no light leaks!
yeah man rockin the pl-ls i have SO much more room now...i'll never use CFLs again!
my adequate space. i want to make that stand there a drawer but i can't find one small enough. the black strip you see there is to keep much of the light out of the top.
the hole to my top compartment right now. this is part of my heat problem, i'm sure; it's only a 2x3" cut. i think i'm going to cut a hole big enough for a 120mm fan, put that right above the sockets (the hottest part) and put a carbon filter over that.
utility compartment...ballast is screwed in up there, fan, power strip and the hole for air from the bottom
in case you don't want to browse through the old thread, here is what it used to look like:
and then this is the one before that (thinking of using it as a mom cab if i decide to perch a bit)
any questions please ask, i can't wait to get started!
lights in the room on, lights in the room off, the sheet i made from black plastic and white vinyl...it needs to be replaced. hopefully when replaced with real black/white poly, i can get no light leaks!
yeah man rockin the pl-ls i have SO much more room now...i'll never use CFLs again!
my adequate space. i want to make that stand there a drawer but i can't find one small enough. the black strip you see there is to keep much of the light out of the top.
the hole to my top compartment right now. this is part of my heat problem, i'm sure; it's only a 2x3" cut. i think i'm going to cut a hole big enough for a 120mm fan, put that right above the sockets (the hottest part) and put a carbon filter over that.
utility compartment...ballast is screwed in up there, fan, power strip and the hole for air from the bottom
in case you don't want to browse through the old thread, here is what it used to look like:
and then this is the one before that (thinking of using it as a mom cab if i decide to perch a bit)
any questions please ask, i can't wait to get started!