I've had some trouble cloning with my usual coco/trays/domes so I've tried my hand with some bubble cloning with neoprene plugs...
First round I got 50% success rate, the failures were clones that damped off. Upon inspection, seems like the condensation from the bubbles that clings to the top of the cloner lid is wetting the neoprene plugs, and that unaerated water is causing the damping off.
How can I prevent this? Lower the water level (it is a few inches below the cutting bottoms already). Physan 20?
Feeling defeated =(
First round I got 50% success rate, the failures were clones that damped off. Upon inspection, seems like the condensation from the bubbles that clings to the top of the cloner lid is wetting the neoprene plugs, and that unaerated water is causing the damping off.
How can I prevent this? Lower the water level (it is a few inches below the cutting bottoms already). Physan 20?
Feeling defeated =(