Burnside GC
Member
White Super Skunk Shatter
![162a51f0aa3411e396d0128cb3735abf_8.jpg](http://distilleryimage7.ak.instagram.com/162a51f0aa3411e396d0128cb3735abf_8.jpg)
dunno dude.
I make my BHO in a pyrex while doing bain marie at same time (following the basic ules fo safety, ie outdoor,no flame, no mobile, no wool sweate, hehehe) in order to keep the oil as less time as possible disolved into the butane.
Bet someone can add more.
Same oil.
Just made:
View Image
After a long journey (high temps, crushed, etc)
View Image
View Image
View Image
^^ MadHaze D...the hazey one.
but still it taste nice!
vibes
If you have no vacuum purge, use a heat gun from the top, while it sits on 115f water bath. Make quick passes over the top with the heat gun (4-6 inches or so away), making sure the oil doesn't go above 125-130f., I use to only pass over the top for 15-20 seconds, then wait a few minutes with just heat from below. You'll notice larger bubbles pop, then smaller ones form. Don't pop the smaller ones yet, let them build with no heat from the top. As they get lager, make another run with a heat gun.
Repeat until bubbles stop forming. Will it get all butane out? Not likely. Will it get lots out, to where you can feel better about smoking/dabbing it? Yes.
thanks - so thats the key then? a low heat until the bubbles have popped/disappeared?
I see people with their little ovens - could I not just stick it in the oven on a very low heat for a while? How long? 12 hours?
thanks for any input guys
I used a plunge pot caffetiere, put my 33g in it followed by 2 cans butane (newport), left it 5 mins, sunk plunger and filtered thru coffee filter
I think you hurried, you could usefully hold much longer.
i was just going to ask.. how is anyone getting these huge yields per zip of nugs.. lol.. why are sooo many people getting under a quarter of oil per zip of nugs.. ?