St. Phatty
Active member
On one of my light panels the plastic part came off leaving the base in the socket.
It doesn't light even though it's hard wired to the other lights.
How do you get the base out when there's virtually nothing to grab on to ?
I was going to jam some needle-nose pliars into the base part, with power off, and twist it.
It's being slightly ornary for a little broken electronic part.
Worst case is I can cut the wires to the socket with the broken bulb base, and wrench the socket off the light panel (it's glued on).
It was one of those little grow room technical problems I was ignorring because the light on the broken bulb was working.
Anyway I figure I'm only about the millionth person to have this happen to.
It doesn't light even though it's hard wired to the other lights.
How do you get the base out when there's virtually nothing to grab on to ?
I was going to jam some needle-nose pliars into the base part, with power off, and twist it.
It's being slightly ornary for a little broken electronic part.
Worst case is I can cut the wires to the socket with the broken bulb base, and wrench the socket off the light panel (it's glued on).
It was one of those little grow room technical problems I was ignorring because the light on the broken bulb was working.
Anyway I figure I'm only about the millionth person to have this happen to.