IndoorScore
Member
Update: actually got in and measured yesterday, pretty off in terms of dimensions. Attic is 100x10-12ft, widest at the ends. about 2ft of height at the wall, 7ft in the middle with approximately 70 inches of width in the center with at least 60" of vertical space. Current plan is to do a flowering chamber at either end of the attic reserving the central space for a workbench, drying and curing and veg room.
I'm insanely concerned with how to light and cool with such limited headroom. Was planning on going with a 10" inline exhaust, but am now thinking maybe I'm better off getting two separate exhaust fans, one for each flowering chamber? Thinking CMH or LED is the way to go for electrical efficiency as well as radiant heat without a giant gap, but looks like 5-6k just in leds. I may end up doing a combination of the two.
I'm going to have to have someone come wire up some outlets and whatever else, but there is already some power up there, the air handler is on one circuit and the overhead lighting I believe is on another.
Just got a 100a panel put in, should be okay considering it's a 1000sqft condo and my stove is gas.
Any better idea of layout setups? Not a ton of height to work with obviously, probably end up doing some type of scrog, my usual MO is hand watered hempy buckets, just fim once or twice and let em roll. This is only my 3rd or 4th grow so while I hope the entire space is eventually built out, I'm not planning on completing it all this go around.
From the other side
Where the wall kicks out a little bit at the end of the span, probably where I'll mount T5 and start seedlings and clones.
I'm insanely concerned with how to light and cool with such limited headroom. Was planning on going with a 10" inline exhaust, but am now thinking maybe I'm better off getting two separate exhaust fans, one for each flowering chamber? Thinking CMH or LED is the way to go for electrical efficiency as well as radiant heat without a giant gap, but looks like 5-6k just in leds. I may end up doing a combination of the two.
I'm going to have to have someone come wire up some outlets and whatever else, but there is already some power up there, the air handler is on one circuit and the overhead lighting I believe is on another.
Just got a 100a panel put in, should be okay considering it's a 1000sqft condo and my stove is gas.
Any better idea of layout setups? Not a ton of height to work with obviously, probably end up doing some type of scrog, my usual MO is hand watered hempy buckets, just fim once or twice and let em roll. This is only my 3rd or 4th grow so while I hope the entire space is eventually built out, I'm not planning on completing it all this go around.
From the other side
Where the wall kicks out a little bit at the end of the span, probably where I'll mount T5 and start seedlings and clones.
Last edited: