What's new
  • As of today ICMag has his own Discord server. In this Discord server you can chat, talk with eachother, listen to music, share stories and pictures...and much more. Join now and let's grow together! Join ICMag Discord here! More details in this thread here: here.
  • ICMag and The Vault are running a NEW contest in October! You can check it here. Prizes are seeds & forum premium access. Come join in!

LST training in detail. Why bushes are better

G

Guest

Bushes are ideal plants to grow for anyone who has a small HID flower light (under 400 watts) or uses fluoros. Smaller lights and fluoros emit the most intense light for only a short distance, so keeping as much vegetative growth in the lights sweet spot is a must to make your lights most efficient. SCROGgers take maximum advantage of this by weaving tops through a screen so only tops are exposed to the light. Well, training attempts to achieve the same goals only with a less work intensive method that will make more use of your small lights limited effectiveness

In the first pic, the plant is tied over so the top is beyond a right angle to the soil. This redistributes a hormone called auxins which are responsible for the dominant growth on the plant. Sending auxins to all branching along the stem makes most if not all nodes grow out evenly.

111training_SC.JPG


After a week, you can release the plant from it's inverted position. Then tie the plant back down to a planter with screws or something in the side as tie down points. This pic shows the verticle support

111training_SC1-med.JPG


The second tie again makes it horizontal to maintain auxin distribution to branching (planter is reversed)

111training_SC2-med.JPG


After a few days, the top has raised itself over the nodes

111training_SC3-med.JPG


Raise your base tie a node and pulling the plant over so the top lifts almost upright again. Note that branch on the very bottom for later. It is now receiving it's share of auxins, something it usually would never see and be trimmed out by any grower seeing it on a single cola plant

111training_SC4-med.JPG


Then tie your top back below the next highest node

111training_SC5-med.JPG


Once again, after a couple of days, the top has worked it's way up

111SC6-med.JPG



Raise the base tie and pull the plant up

111SC7-med.JPG



Raise the top tie a node and pull horizontal

111SC8-med.JPG


Several days later, re-training will not be necessary since the top isn't growing over the nodes anymore. This is a very dry plant in these pics and I will be watering her tonight. The growth spurt in the next few pics should be impressive.

111SC9-med.JPG


An example of the auxins at work. Here is that lowest node on the plant, almost buried under the topsoil. No untrained or topped plant would grow nodes out so uniform that even this would be weakling could join the harvest party..

111SC10-med.JPG


111SC11-med.JPG


111SC12-med.JPG


111SC13-med.JPG
 
G

Guest

This plant is now ready for flowering even though the last pics show my new clone mother. The same size rule applies to growing bushes, expect each branch to grow 2-3 times as large in the stretch as it is when you switch.

The time to leave bushes in veg is determined by your flower light and how tall you want the plants to grow. The plant in the last pics took 19 days to reach the point you see in the last pic. With an 8 week fowering period, thats only 10 weeks (or so) from cutting to harvest.
 

sm0kateer4204

Active member
Veteran
yeah lst is great for any small scale grower ive been thinking of doing somthing different lst worked great for me but i may try supercropping
 
G

Guest

LST (Low Stress Training) is supercropping perfected. This is by far a better way to train plants then snapping the hurd or stem crushing.
 
G

Guest

Wow, man!

Wow, man!

Caprichoso,

Your threads are always so informative. Great stuff. You're a very good teacher.

Keep the good stuff coming.
 

friendlyfriend

Active member
Veteran
I crush stems incessantly, masochistic perhaps but I like your method becuase it does have extraordinairy results.... think you get more than a scrog? that would be interesting to compare yeilds based on two identical grows one scrog and one LST to the max ala capri! wut a concept
 

PassTheDoobie

Bodhisattva of the Earth
ICMag Donor
Veteran
I got lucky

I got lucky

I started bending stems and flower tops from my first grow and got pretty good at it. I had no idea it was a technique called LST. I use pipes cleaners, rather than little ropes. Does it matter how you achieve the manipulation of the auxins for the technique to be LST?
 
G

Guest

friendlyfriend said:
I crush stems incessantly, masochistic perhaps but I like your method becuase it does have extraordinairy results.... think you get more than a scrog? that would be interesting to compare yeilds based on two identical grows one scrog and one LST to the max ala capri! wut a concept

Crushing the stem was how I got a multicola plant for the first two years I was growing. Do a side by side comparison and see the difference in how even the branching grows out. It became obvious to me that when crushing or snapping the hurd, there was a significant delay in the growth of the nodes above the damage, two or three days. That's a lot when your clones only spend 18-20 days in veg after rooting. True, the branching below the damage took off as compensation, but that led to my plants being very uneven during the stretch and having to do a lot of work to keep an even canopy. LST makes everything grow out so evenly, you swear the entire plant is in stasis for a few days until you see things like that lowest branch seen above growing out like it is.

PassTheDoobie said:
I started bending stems and flower tops from my first grow and got pretty good at it. I had no idea it was a technique called LST. I use pipes cleaners, rather than little ropes. Does it matter how you achieve the manipulation of the auxins for the technique to be LST?

Not at all. What matters is that you don't damage the plant when doing the initial training to get the branching to grow out. I've seen many ways of training, including using hooks and fishing weights to lower branches (plant looked like a X-mas tree)

I have a slightly different opinion of hurd snapping after the initial training is over. In fact, snapping the hurd on stretching branches is my favorite way to control height without more ties. Ive been known to top them as well. When it's done for individual branch training and height control, hurd crushing and topping both have a place in my room. I just wont do them for axial growth.
 

amsterdame

Member
Very cool and informative thead, Cap!

Following your instructions, I started LST with 7 northernberries and 6 bogbubbles a couple weeks ago and am digging the results. I'd been considering scrogging for awhile, but much prefer the lst technique. Seems a lil less labor intensive.

I'm using small size binder clips and a roll of sturdy twists for the tie-downs. The process is a breeze and there's no prep needed for the containers.

Thanks for sharing this great technique in detail!

Peace,
A*dame
 

B.C.

Non Conformist
Veteran
Right on Cap

Right on Cap

Excellent job of showing and explaining how lst is done. I've used this method for awhile now and it almost doubles my yeild, espc. those low yeilders like blueberry ( with blueberry you have to do it when the plant is very young other wise it gets woody fast and will not bend ) It takes a little longer in the veg. room but def. worth it !
 

Harry Gypsna

Dirty hippy Bastard
Veteran
Im off 2 my grow in a bit, and i have a couple plants that are ready for this, so it starts tonight, i never liked chopping bits off em, to top, shit, i am gutted when i have to cull a male:rolleyes: So, if i get this down and it turns out good, no more topping for me. muchas thanks man:wave:
 
Hey Cap,
Thank you for the great pictures and invalid help to all about the training techniques used too manipulate for optimol yields under low lighting systems and smaller grow rooms this technique I practice all the time and have learned like you the bennefits we are rewarded with. I love to bend plants and watch as they respond in a very positive manner. Thank's for popping in and saying hello in both of my Journals I appretiate the nice words of encouragement and also your invalid expert journals. We all learn from one another and it's great to be part of this learning curve.

Glad that there are others who also recycle soil Cap...

Peace....
 

agent 420

Member
impressive grow caprichoso. your use of LST is also quite amazing. i was wondering, after you create the initial bend in the stem, do you have to keep it tied down for the whole grow? if you un-tie the stem, will it begin to grow straight?
 

wickyd

Member
agent, eventually the stem of the plant will thicken up around the bend, and it'll hold its shape, and you get to tie down each of the lower branches, to further train the plant, and get more budsights.

wickyd
 
G

Guest

You can remove the initial tie for training after a week, but the plant should continue to be tied down for awhile until the branching gets some rope on it. After a few have been pulled down and secured, the main stem ties can be removed.
 

Latest posts

Latest posts

Top