Skunkmasterflex
Member
You need:
:1 steel tube from B&Q
:1 hose jubilee clip
:1 small piece of steel mesh
:1 Clipper Lighter
To make:
:Cut tube to required length.
:Cut mesh big enough to cover and poke out on the corners so the jubilee clip holds it in place.
:Cut lighter in half ,plug bottom half in the tube should be a snug fit if not use some insulation tape.
:Oh yeah you'll want to put your bud ,leave's ,kif whatever your extracting in first.
I Extract into a pyrex dish ,when all butane's evaprated I pour in warm water put it on the hob on low this soften's the goo much easier also purges it quickly.
I yeilded 0.7 from 11g's of close trim it took two run's using half a can of Newport tripple purified each run.
The pic's are crap ,if u look close at the end of the knife theres some that i whipped with a pin and let it dry ,looks like kif.
This cost me under a fiver got all the bit's from B&Q (apart from the clipper).
:1 steel tube from B&Q
:1 hose jubilee clip
:1 small piece of steel mesh
:1 Clipper Lighter
To make:
:Cut tube to required length.
:Cut mesh big enough to cover and poke out on the corners so the jubilee clip holds it in place.
:Cut lighter in half ,plug bottom half in the tube should be a snug fit if not use some insulation tape.
:Oh yeah you'll want to put your bud ,leave's ,kif whatever your extracting in first.
I Extract into a pyrex dish ,when all butane's evaprated I pour in warm water put it on the hob on low this soften's the goo much easier also purges it quickly.
I yeilded 0.7 from 11g's of close trim it took two run's using half a can of Newport tripple purified each run.
The pic's are crap ,if u look close at the end of the knife theres some that i whipped with a pin and let it dry ,looks like kif.
This cost me under a fiver got all the bit's from B&Q (apart from the clipper).