Are charcoal filters bi-directional ? - Growroom Designs & Equipment - International Cannagraphic Magazine Forums

stewart169 · 08-04-2017, 05:09 AM

I don't think it matters but don't know for sure or have seen manufacturers guides. Does it matter which way air flows thru a charcoal filter like a phresh filter ??

Chilly Willy · 08-04-2017, 06:28 AM

Yes, and No. If the filter has already been used for a duration of time while they smelled then when you reverse the flow all that was filtered before is now on the outer edge. So you would be filtering, and the dirty part of the filter is exposed and getting into the air.

These filters work great, just decide in advance which way you want the air to flow! The only time my grow had an odor was in veg... there are also other ways that cost less to get through that short time period.

stewart169 · 08-04-2017, 07:11 AM

Quote:

Originally Posted by Chilly Willy

Yes, and No. If the filter has already been used for a duration of time while they smelled then when you reverse the flow all that was filtered before is now on the outer edge. So you would be filtering, and the dirty part of the filter is exposed and getting into the air.

These filters work great, just decide in advance which way you want the air to flow! The only time my grow had an odor was in veg... there are also other ways that cost less to get through that short time period.

I know they work great. I have used them for a few years. What I want to know is if a new out of box filter can be used to flow from the inlet side to the outside surface with no issues. I understand this is reversed for most uses but Im re-tasking it as a room filter using existing cold air returns to vent smoke to the attic area with a Y splitter and back flow damper on a different switch used when smoking in the den. I dont want to spend the bucks to buy an inline filter which is much more expensive. Think of a quiet S&P fan blowing thru a filter for a den for smoking and not smelling up the whole house. Otherwise the cold air return is used to flow air back to HVAC.

Chilly Willy · 08-04-2017, 07:37 AM

this will dirty up your HVAC system.

Chilly Willy · 08-04-2017, 07:48 AM

measure entire living area, get correct size equiment.

Chilly Willy · 08-04-2017, 07:57 AM

good luck.

packratt · 08-04-2017, 02:19 PM

I've used them both ways, push, and pull. It's all good, works the same.

08-04-2017, 05:09 AM	#1
stewart169 IC Mag Supporter Join Date: Oct 2016 Posts: 397	Are charcoal filters bi-directional ? I don't think it matters but don't know for sure or have seen manufacturers guides. Does it matter which way air flows thru a charcoal filter like a phresh filter ??
	Quote

08-04-2017, 06:28 AM	#2
Chilly Willy Banned Join Date: Jul 2017 Location: The Bahamas: Where it's not cold! Posts: 115	Yes, and No. If the filter has already been used for a duration of time while they smelled then when you reverse the flow all that was filtered before is now on the outer edge. So you would be filtering, and the dirty part of the filter is exposed and getting into the air. These filters work great, just decide in advance which way you want the air to flow! The only time my grow had an odor was in veg... there are also other ways that cost less to get through that short time period. Last edited by Chilly Willy; 08-04-2017 at 08:24 AM..
	Quote

08-04-2017, 07:37 AM	#4
Chilly Willy Banned Join Date: Jul 2017 Location: The Bahamas: Where it's not cold! Posts: 115	this will dirty up your HVAC system. Last edited by Chilly Willy; 08-04-2017 at 08:25 AM..
	Quote

08-04-2017, 07:48 AM	#5
Chilly Willy Banned Join Date: Jul 2017 Location: The Bahamas: Where it's not cold! Posts: 115	measure entire living area, get correct size equiment. Last edited by Chilly Willy; 08-04-2017 at 08:25 AM..
	Quote

08-04-2017, 07:57 AM	#6
Chilly Willy Banned Join Date: Jul 2017 Location: The Bahamas: Where it's not cold! Posts: 115	good luck. Last edited by Chilly Willy; 08-04-2017 at 08:26 AM..
	Quote

08-04-2017, 02:19 PM	#7
packratt Member Join Date: Jun 2017 Posts: 78	I've used them both ways, push, and pull. It's all good, works the same.
	Quote 1 members found this post helpful.