So i bought a new RO the old one was about done for.
The water on the new RO is 40 ppms but the ph is 3.9 -4.0.
Anyone ever experience this ?
Brand NEW ph / tds meter and calibrated.
(Well water very dirty 600 - 700 ppm lots of iron. The ph was about 7.4 before and after sending it through the OLD RO machine but the ppms where about 330 > the reason i replaced it, older model couldnt find the filters)
Seperate question, should i add some tap to the RO water try to get it between 50 - 100pms mixed ?
The water on the new RO is 40 ppms but the ph is 3.9 -4.0.
Anyone ever experience this ?
Brand NEW ph / tds meter and calibrated.
(Well water very dirty 600 - 700 ppm lots of iron. The ph was about 7.4 before and after sending it through the OLD RO machine but the ppms where about 330 > the reason i replaced it, older model couldnt find the filters)
Seperate question, should i add some tap to the RO water try to get it between 50 - 100pms mixed ?