I'm currently building my 4x4 grow tent set up based around the Kind LED xl750. It is in my finished basement, in a corner surrounded by 3 walls. I posted the temp and humidity level of the tent with nothing running yet. My plan was the run a 4" exhaust fan with carbon filter out the rear port, and run ducting above my bathroom, which is next to the tent.
Could i just stop there, and have that air just blow back into my house? Again, there will be a carbon filter, and any heat it gives off will be fine with me, as the basement is cool all year round.
Or could i splice that ducting in to my current hot water tank exhaust duct, which leads outside?
I'm trying to avoid having to drill through my walls to add another exhaust duct just for a small led based set up.
Also, as far as air intake goes, would a 4" intake fan with a carbon filter or horti-control dust shroom be overkill? or should i just expect to be able to get good enough intake from the rectangle ventilation ports on the bottom of the tent?
I will be running one or two 6" clip on fans on the inside for circulation.
Any advise would be greatly appreciated.
Could i just stop there, and have that air just blow back into my house? Again, there will be a carbon filter, and any heat it gives off will be fine with me, as the basement is cool all year round.
Or could i splice that ducting in to my current hot water tank exhaust duct, which leads outside?
I'm trying to avoid having to drill through my walls to add another exhaust duct just for a small led based set up.
Also, as far as air intake goes, would a 4" intake fan with a carbon filter or horti-control dust shroom be overkill? or should i just expect to be able to get good enough intake from the rectangle ventilation ports on the bottom of the tent?
I will be running one or two 6" clip on fans on the inside for circulation.
Any advise would be greatly appreciated.