What's new

Nectar for the Gods HH + Bloom Chaos

mliokv48

Member
Will HH or Bloom Chaos Burn my plants or cause lockouts. I am using sample box for veg but will be going to all (most) other products in week or two. I have been feeding late veg rates with very little Bloom Chaos. I want to give it more BC and HH. Would it be safe to water in Bloom Chaos at 2x foliar strength along with spraying 1/2 strength. Does it matter when I spray in relation to when I feed. Same day next day etc.? Using that much more BC how much more HH should I put in? 30%? Also what can to much do? If I raise my EC that much with non burning nutrients I still can cause feeding problems correct? EC - my understanding is it's like tension. Bigger gap between plant and EC by roots faster the stuff balanced out and then overwhelms plant. Is this correct way to look at it?
 

Bueno Time

Active member
ICMag Donor
Veteran
I used a sample box last round but I didnt get the samples until two weeks into flowering so I started using it right away the whole setup all 6 quarts and the two little bottles. Never foliar sprayed the BK since I was already into flower a couple weeks but I watered it in with the nute mix.

I went with 1/3-1/2 strength of the mid-flower recommendations on the advanced feeding chart.
 

mliokv48

Member
When deciding on strength I can mix at full strength then check EC. Then I can increase water to percentage of EC that I want. Then Ph correct? Also is there a proper way to mix these nutrients or other nutrients? Takes me 5-10 minutes. Should I Ph first then wait Ph again? Is there a right way or wrong way to do it?
What EC did you feed your plants going into flowering do you remember what EC levels you ran?
 

Bueno Time

Active member
ICMag Donor
Veteran
When deciding on strength I can mix at full strength then check EC. Then I can increase water to percentage of EC that I want. Then Ph correct? Also is there a proper way to mix these nutrients or other nutrients? Takes me 5-10 minutes. Should I Ph first then wait Ph again? Is there a right way or wrong way to do it?
What EC did you feed your plants going into flowering do you remember what EC levels you ran?

Where you happy with the results?


I didnt check my EC at all. I just took a 2.5 gallon plastic jug with lid and filled with water to how much I needed to water with and then dumped the amounts of each nute in and shook it up then checked pH and adjusted pH up if needed. I got the measurements down to where I didnt need to adjust pH half the time just mix it up and water. I dont know what medium you are using but I was using FF Ocean Forest and that with the NFTG nutes was really hot hence why I went only 1/3-1/2 strength and at those levels I did get crispy tips on the leaves.

The yield, frost, density, bag appeal were all very good. Smell of the finished buds is good, not amazing, very smooth smoking but really lacks flavor.

I went back to my usual method this round and quit the NFTG line. Im all about the flavor/taste and that's the only thing lacking with the Nectar in my experience.
 
Top