I have a 48x48x76 grow tent with 3x6" holes and 2x4" holes. I have 2x28" long 8" cool tubes in there with 1000w each.
What the best way to hook this up ? Was thinking of having the 2x6" ducts have a reducer on it so I can run 8" ducting inside as a sealed light circuit because I know it is going to get hot in there. I don't need odor control so I am exhausting out the top 6" duct and it creates a negative pressure on the intake so I get fresh air inside. I don't have much space between the walls and the cooltubes, ten inches each side. Should the lights be wired in series or parallel? I think series would be alright because its sealed ventilation, parallel would be a lot more efficient but I don't have enough room to spare to fit 8-6" reducers on each light and y-fittings. Please help I have seven days until my 9 girls are going in.
What the best way to hook this up ? Was thinking of having the 2x6" ducts have a reducer on it so I can run 8" ducting inside as a sealed light circuit because I know it is going to get hot in there. I don't need odor control so I am exhausting out the top 6" duct and it creates a negative pressure on the intake so I get fresh air inside. I don't have much space between the walls and the cooltubes, ten inches each side. Should the lights be wired in series or parallel? I think series would be alright because its sealed ventilation, parallel would be a lot more efficient but I don't have enough room to spare to fit 8-6" reducers on each light and y-fittings. Please help I have seven days until my 9 girls are going in.