michmedclones
Member
Hey guys, setting up a basement with a smaller grow for some medical patients in MI. They want to go barebulb vertical, 4000w, and I'm new to that so I need some help from the masters. They want to run them bare with honeywell fans underneath taking heat up, they have a 340cfm panasonic whisperline as well as a 8" 747cfm vortex inline hooked up to a scrubber which will be run at about half speed, I figured 7-800 cfm would be more then enough combine to change the air every 3 minutes. Anyways I'm not sure about the heat, they want to try to skip ac by having a high exchange rate, which I suggested they tried to change the air every two minutes IMO. I have a few different ideas on how to set it up but I want to know if A) its even possible to do, and B) if theres anything I'm missing thats important, BHO erases my memory and I tend to figure out problems when they arise but since its not my room I don't want to leave them in the dark. I was hoping that the honeywells would take the majority of the heat up to the cieling, I was going to set up the whisperline right in the middle blowing twords the vortex, and then the 8" vortex in the corner below the dryer vent that will be used for the exhaust, changing it every two minutes might help but again, I don't know. I wanted to run a 6" duct fan for a somewhat passive intake from outside that still keeps the negative pressure maintained. (Were in MI so its getting cold so that will help with temps, they could afford A/C after a good harvest or two in the summer if needed) I'll stop rambeling, I think I've given enough info, if I forgot something let me know but if anyone has any experience
Thanks again guys you've always been helpful
Thanks again guys you've always been helpful