Okay let's start with a tour of the build. What I did was make a PVC frame 4x4x5h, the screen is 3' tall and 2.5gal buckets are ziptied to it. In the first pic only the drain for these buckets are plumbed.
Now let's look at my High Pressure Aero Cloner. Since this pick I've flipped the pump upside-down to resolve a priming issue.
This is the timer I built to control it, adjustable from 1-60" ON and 30"-30' OFF. I used a spade bit to thin the case where the potentiometers had to go through.
What it looks like closed up.
Some fine mist from 85PSI.
Here's the result from 3" ON 3' OFF. Hairy roots were mostly visible in the net pot. I've since removed the netting from the pot. Working on cycle times. Too short and they take forever to root, too long and the roots aren't hairy. I'm just experimenting since my next grow will be HP aero. I'm currently building a full HP garden for use with vegetables in my living room. I want some lettuce, damn it.
Moving on from the cloner, this is my Fan/carbon/ballast box. I used a cut-to-fit filter bad held in place by several screws around the perimeter. Topped with about 1" of carbon. And an air cooled ballast to boot. The ballast did require additional support. I wouldn't recommend reproducing this box.
More too come.
Now let's look at my High Pressure Aero Cloner. Since this pick I've flipped the pump upside-down to resolve a priming issue.
This is the timer I built to control it, adjustable from 1-60" ON and 30"-30' OFF. I used a spade bit to thin the case where the potentiometers had to go through.
What it looks like closed up.
Some fine mist from 85PSI.
Here's the result from 3" ON 3' OFF. Hairy roots were mostly visible in the net pot. I've since removed the netting from the pot. Working on cycle times. Too short and they take forever to root, too long and the roots aren't hairy. I'm just experimenting since my next grow will be HP aero. I'm currently building a full HP garden for use with vegetables in my living room. I want some lettuce, damn it.
Moving on from the cloner, this is my Fan/carbon/ballast box. I used a cut-to-fit filter bad held in place by several screws around the perimeter. Topped with about 1" of carbon. And an air cooled ballast to boot. The ballast did require additional support. I wouldn't recommend reproducing this box.
More too come.